Green Ammo SAAB SAT integration
Introduction
Date 10.05.2023
Author: Erik Boye Abrahamsen
Green Ammo SAAB SAT Integration Version: 0.1.0
Green Ammo document version: 0.1
Technical Information
E-blanks will send trigger signal via wire on muzzle attachment to the the SAAB SAT Drytrigger module inside the E-blanks integrated SAT.
Required Equipment
1pc E-blanks kit
2pc of CR2 3v battery
1pc SAAB SAT
1pc E-blanks SAT muzzle
1pc E-blanks integrated SAT
Tools
1pc Flathead screwdriver
Pairing SAT to SAT PCBA
When the SAT and E-blanks integrated SAT is powered and ready.
Put the pairing port of the SAT to the pairing sensor on the SAT PCBA
Installation
The complete installation process is shown below.
Before use make sure everything is charged fully and E-blanks is installed correctly
The general workflow are shown below:
- Make sure E-blanks is installed and is working correctly in the weapon.
- Remove the back lid of the SAAB SAT and install the CR2 battery.
- Unscrew the front of the E-blanks integrated SAT, and gently pull out the SAT PCBA.
- Install the CR2 battery into the SAT PCBA.
- If the SAAB SAT is not paired it can be paired here, or later when it is installed. See pair section.
- Assmble the E-blanks integrated SAT again, and mount it on the weapon.
- Install the E-blanks SAT Muzzle and insert the cable into the integrated SAT unit.
- Pull the charging handle to load in a round from the E-mag.
- Now everything should be ready!.
Prepearing the SAT
Open the back lid of the SAT with the flathead screwdriver.
Install the CR2 battery, make sure you follow the orientation schematic inside the SAT.
Close the lid, make sure the light blinks green.
Prepearing the E-blanks integrated SAT
Unscrew the front cap(Make sure you dont lose the glass or the O-ring).
Take out the PCBA carefully, and insert the CR2 battery.
Insert the PCBA with battery into the lower slots (Marked in red on the image).
Screw the front cap back on tight, but not so tight it breaks(It is plastic afterall)
Installing on the weapon
Insert the muzzle rod into the E-blanks SAT muzzle.
Connect the trigger cable from the E-blanks SAT Muzzle into the E-blanks integrated SAT.
Slide it onto the rail of the weapon.
(The E-blanks integrated SAT will blink a LED when active and when shooting)
It is suggested to install it with the glass towards the user, or to tape out the glass.
Usage
To use it simply shoot with E-blanks and it will trigger the SAT.